Separate names with a comma.
Here's the setup that I was describing. A 10A analog 12V charger will converge to 0A at around 15.5V. I tried 40A for grins, but it made the...
Charging setup using an analog 12V charger to charge two NiMH modules in series
Closeup of connection, using a 12V charger to charge two modules in series. This charger was set to 10 amps. Here it delivers 1 amp at 14.66V....
Not sure if it is better to remove the fuse or the relay, I'd personally pull the relay, but each are labeled EMPS, and are in the engine...
The steering is harder when the car is moving slowly but should be fine at highway speeds, just a little stiffer. You'll notice more when making...
Disconnect all of the bus bars on one side -- the side with the sense wires. If you have linesman's gloves and insulated tools, use them for this...
I use SuperMate DC6. However, you can use a 12V battery charger and charge 2 at a time in series. A dumb 12V charger is better, like an analog...
There is a TSB out on this....
Elen, I am so sorry to hear that. All indications are that it is the rack, still. Did you call Hillmuth back and let them know? Definitely do...
Yep, you need to pull the traction battery, and it does explain the no-start.
What they are telling you has almost no resemblance to the trouble codes. It is very slightly possible that, with the gross EVAP leak, enough...
To make the numbers easier, suppose that, at 60 MPH, the energy consumption is 250 Watt hours per mile. That means a power requirement is 15 kW....
How about door #3? Take your car to a hybrid shop on this list, several in MA: Preferred Independent Hybrid Car Repair and Service Shops |...
0440, 0441, 0446 -- these are all EVAP codes. There is a gross leak somewhere. That could cause random misfiring at idle. It could be something...
P3125 is a Gen 1 code. If yours is a 2005, whoever gave you the diagnosis messed up completely. Don't go back. Get your car down to AutoBeYours...
No problem, I was just curious.
That's actually a good point, to have a 3/8" drive in-lb torque wrench (like 240 or 360 in-lb) if doing 10mm sized nuts/bolts etc. Even though it...
Hey OutWest, can you give us some insight into transaxle fluid changes in your shop, specifically Gen II? Unfortunately, all we have here are...
There are great deals on Amazon. You should also buy your friend a breaker bar. I have the 25-250 lb version of this, for when the capacity of...
P3030 is for a bad sense wire in the HV battery. You'll need to remove the battery from the car, take the cover off, and see what's going on....
