Separate names with a comma.
On the lift, front view
Passenger side front. Heaviest impact here. Will replace side rail.
Driver's side front. CHS is intact. Will replace side rail
On the lift, side view
2006, 78K -- no problem whatsoever to expect at least a few more completely trouble-free years. Failures reported here so far have been older,...
Must be talking about inverter coolant. If you had to pick one fluid in the car to NOT change, it would be a tossup between that and brake fluid.
That's interesting, 9 out of 10 tow truck drivers don't know S*** about how the Prius works. I don't know that there is much juice left in the...
This is one that we are still trying to sort out. While driving, when it codes, the DC converter, which charges the 12V, goes offline, as does...
Insurance companies have given the Prius a very low total loss threshold. For front-end collisions, this is very much deserved, because the...
Replacing the Inverter Assembly on a 2002 1st Gen Prius « Russ' Do It Yourself Home Workshop Unfortunately, the Gen I area is the ugly...
44 on the front is quite stiff. If the tires are old and worn, then, particularly at highway speeds, the ride is bound to be rough and...
E2 is the wire leading into the ECM, at pin #28 on connector E4. It is brown. I would think you'd have a lot more problems if the wire was...
Are you comfortable taking apart brakes? I would check the caliper slide pins first. It is possible that they have some major rust on them....
Okay, P1118 is the sensor or a wiring problem. Did you not also have P0137? These are both open circuit codes. The service manual mentions...
It is safe to drive for several miles from a COLD start. It is similar to having a broken water pump on an engine, the main difference being that...
There are endless variables to control in this type of experiment. Do you both have the same exact tyre, at the same pressure, with the same...
Your trusted source is wrong. SLLC was used in all 2004 models, not just Prius, as far as I know. I've never heard of a prohibition on adding it...
Not sure if 10 and 11 are different. Kimo, the tint suggestion is related possible sources of interference described in the service manual. I...
Try following the initialization procedure in the attached service bulletin. It is possible that the techs just aren't doing it right, i.e....
If, after being in D or R, you find that the gear position reverts to N, such as when turning a corner, replace the shifter assembly. Warranty...
