Separate names with a comma.
Those prices are super low. If he can do the head gasket job properly for $1500, go for it. Also @bisco, $1600 is wholesale cost for a Gen 2...
Sure thing, let me know if I can help. I just did the job last month so it is fairly fresh in my mind. I would top off the coolant and pressure...
Are you losing any coolant? Check the coolant level in your reservoir.
Can you post the final repair invoice so that we can see the notes on why they had to go with a used engine?
Strangely enough, I have never had issues with bleeding these systems. The way I do it is that I fill the system, then I allow the car to idle in...
I have never done the brake flush using the ECB invalid mode. I have always performed the brake flush using the guided function in Techstream or...
From the 5 or 6 of these that I have done, after every brake flush, there will be several stored fault codes related to the process that have to...
I can only foresee two scenarios: 1) too much material was removed from the cyl head so after re-installation, the timing marks would not line...
Did the head bolts pull threads from the block upon reassembly? That is what it sounds like to me. Hate to say it, but this is not exactly...
I HIGHLY recommend that you do not attempt to flush the brake fluid if you do not have access to Techstream or an equivalent aftermarket scan tool...
That crossed my mind too. But I would expect the heat from that unit to cause the engine to overheat all of the time, not just under heavy load...
I am replacing the air/fuel sensor on my 2011 due to mileage (187K) and possible anti-freeze contamination from the recent head gasket failure....
I have never had any issues with bleeding this cooling system so I am skeptical that air pockets are the problem here. I assume that you are not...
I am considering the Idemitsu ZEPRO w/Advanced Moly 0W-20 for my 2011 Prius. My cost on this oil is the same as Mobil 1 EP so the price is...
Are both hoses going into and out of the heater core, hot? The fact that one rad hose is cool and the other is hot leads me to believe that you...
Any updates?
Can the upper oil pan be removed without removing the short block?
Since the O/P has already had their head resurfaced and has the full overhaul gasket set in their possession, I am suggesting a new gen 3 short...
I use an inspection camera to check each cylinder for coolant intrusion. Try to find one locally if you don’t have one already.
I would remove the spark plugs in the morning (after the car has been sitting all night) and check for coolant leakage. If there is no leakage,...
