Separate names with a comma.
I finally got my Android tablet to work with Dr. Prius. The secret to making it function was to finger touch the MAC address shown in the app's...
Does the Prius have to be in ready mode (and not just on) in order to read codes?
I acquired a Bluetooth OBDII module (vendor=BAFX) and downloaded the Dr. Prius app to an Android tablet. Did I miss the user guide that tells me...
I'm an Indiana electrical engineer with a lot of mech skills and tools. I've watched the esteemed Steve and Jenny Woodruff at...
Clearly a lot of thought and tooling money went into making that "blade". The injection mold for the case alone would pay my wages for a few...
YouTube videos have convinced me that transplanting a Gen 4 motor into a dead Gen 3 Prius (2013MY) is a doable task. Those who have done it on...
"marketers on this board only sell lift kits and replacement battery cells." And the availability rebuilt 2ZR-FXE motors in the commercial market...
After re-reading ChapmanF's thorough reply and discussing it with another Gen 3 Prius owner, I summarize/internalize what Chapman wrote like this:...
Thanks to all of you for your helpful comments. Don't know how Indiana cultivates so many steely-eyed Prius partisans. :)
I am a Gen 2 and Gen 3 Prius veteran who has cleaned out his Gen 3 EGR loop including unplugging the blasted heat exchanger. I have friends and...
My wayward nephew is not mechanically inclined and can't get motivated to check his oil level periodically. Today I added 2 quarts to bring the...
Both of these comments were quite helpful, especially the comment on bent knuckles. On the question “which brand was installed” I think the...
I recently had both front wheel bearings replaced on my 2006 Prius at 185k miles. This is the third set of front wheel bearings on this vehicle....
I wanted to express thanks to you directly for your help today on my MAP sensor question. You must be an EE as I am because you appear to have...
[ATTACH] Thanks for the help, Chapman. Nice clear wiring diagram as if you drew it your yourself using Altium Designer or OrCAD schematic...
I have the same P0108 MAP sensor problem on my 2010 that you posted about. I'm trying to chase the open ground problem you chased. A...
Mendel, my thanks to you for your many helpful comments to my PriusChat postings through the years. Can you suggest where I might find a pin-out...
@Bookkeeper, could you elaborate where you found the chewed open ground lead to the sensor? I have the same problem on my 2010. I get P0108 on...
Earlier this week I posted a bitchy message to this forum talking about the failure of my HID headlight electronic ballast caused by the headlight...
I'd pass on buying it. You're looking at replacement of front wheel bearings and sway bar bushings. The variable valve timing servo probably...
