Separate names with a comma.
I accidentally broke off a couple of the plastic clips on the front bumper that hold the grille on. Do they make an aftermarket grille that screws in?
It's a felt washer of some kind. I did some testing and the bumper stayed on just as tight with 2 of the 4 plastic pieces that pierce the sheet...
Finally found it! Gasket holding the rear bumper attachment bracket was split in half, allowing water in. [IMG]
I keep getting water where I painted in red. [IMG] There was a crack in the metal near the top below the weather stripping, which I sanded and...
Interesting data point... After replacing my fake fuel injectors, MPG did not improve. After leaving the 12v battery unhooked all night, it went...
Here are the fuel trims: [IMG] [IMG] [IMG]
I was reading on a 2nd gen Facebook group about how you "can't go by the MPG readout on the dash and have to track miles and how much gas it...
Long term fuel trim over 50 miles was 5%. Is this good or bad?
I ended up ordering new intake and exhaust ducts because I tried 2 different kinds of foam and neither squished enough to fit. Even with the foam...
Since y'all were worried about the foam or backer creeping over a module, I ran my borescope through the other side before assembly. [IMG] Clean...
eBay.
The suspected fakes were used in the engine once rebuilt, and I think causing the engine to run rich and get carbon on top of the pistons in under...
In all honesty the design of the battery in the 2nd gen is terrible. For starters the foam they used on air sealing areas is very low density and...
The pack has maybe 3 years left, if that. I'm not going to put money into it, like I said my current Prius will be old enough to vote next year,...
Laugh all you want, but keep in mind when this pack goes, it's either getting replaced or the car is. I added some foam blocking before using...
Speaking of battery, I plan on replacing it this fall or next spring, should I buy reman or new, and where is the cheapest place for either?
[IMG] So from the factory manual itself, airflow is supposed to completely stop before the separate area that houses the electronics and flow...
This is not my battery, but I noticed mine doesn't have this black plastic piece near the computer. Will this hurt airflow? [IMG]
[IMG] Been bugging me for a long time.
Things are taking shape. Got new foam installed on the top cover. Had to glue it down on the curves. The old adhesive was still tacky which helped...
