Separate names with a comma.
Looking at other used dampers, a lot of them don't match up, some are WAY OFF. Which is really odd because those outer marks are supposed to be...
Engine was installed in time. No slack in timing chain. But here is what I discovered... [IMG] Piston #1 is set to TDC, cam marks and chain...
The new solenoid didn't fix it. Could the ECM possibly be bad?
I keep getting P0016 "cam and crank timing correlation". I took the valve cover off, set Cyl 1 and verified both cam shafts and crank were in...
I can't seem to find it.
Have you ever used leak detection dye?
[IMG] It looks like the bottom of the timing chain cover, but then I saw a bit on the area and bolt above it. Don't see any drip down from the...
Finally got it solved. [IMG] The tie rods I bought, one is marked "L" and one would assume this means "left". Apparently the L is a foundry or...
So I got the ball joints set good and they aren't rubbing. I figured out the wheel is hitting the inner tie rod. I think there is more thread...
The ball joints for this car are not driver/passenger side specific, the control arms however, are.
Swapped the control arms and it's still doing it. I looked at the install video: [IMG] You can see the old joint has much more thread...
I tried. I had to end up heating it with a torch until the nut was red and still had to use 2 12" long wrenches with my knee adding weight to bust...
Part of the reason they didn't align it is because the threads were rusted horribly on the inner tie rod ends. But they called and asked me about...
I mailed them a letter asking for half the bill back. Bill was over $400, and here is everything they did wrong. 1. Installed lower control arms...
I figured it out, and boy am I pissed! Here's my LCA. [IMG] Here's the one the a shop put in on YT, same brand! [IMG] The shop put them...
This is the ball joint with the car on jack stands. There's a decent amount of space, about 0.6". [IMG] I lifted the LCA up and put the weight...
I went through a divorce so it was at a tire shop near where I used to live. Bill was close to $500 and I asked them to align it, and they...
The shield isn't the cause. One side was rotten, so I removed it. When I had the wheel cranked all the way, the ball joint itself was contacting...
I'm wondering if when they installed the lower control arms, if they didn't load them when tightening the bolts. Most LCA's have to be installed...
Prior shop installed all new tie rods, lower control arms, struts and ball joints. Now when making sharp left or right turns, the ball joints are...
