Separate names with a comma.
Thanks for all the feedback! I now have just one more issue...I hope! I got all the marks correct and they tried to release the tensioner. I saw...
The number of links between the timing marks would is good to know. In fact, it's 10.5 links between the chain marks or 6 5/8 inches between the...
I'm hoping I've figured this out correctly but just wanted to run it past someone. When I was taking the cylinder head off, I had removed the...
I did call permatex today and they said their Ultra Black would work well as it has high oil resistance and can take up to 500 degrees and high...
I need to know what to use to seal the camshaft housing, espeially right above the exhaust manifold. I have some Permatex Ultra Black the is good...
Yep, they still charged but they've done good work for me before at reasonable prices. I'm guessing they should have cut it off and drilled it out?
I was trying to remove the locator/roll pin that came out with the cylinder head when I removed the head. The one close to the cam sprockets...
Felpro told me today that any average roughness 50 or less will work with their Prius gasket. Most machine shops have a tool that will measure...
Could be. I'm really not an expert on this. My understanding is that the Toyota spec is 30 to 60 ra which means average roughness and has to do...
Thanks for the replies. I talked with the Felpro guy and he thought it was a potential big problem but my guess is it's not, due to the oil...
When the cylinder head was off and camshafts were removed, two lifters fell out. I think they're back where they belong but not sure. At least I...
I'm putting the water pump back on and I notice a gap between the plastic spacer and the pump motor. There's a gasket that goes between the pump...
Talked with felpro technical about average roughness on the head and they said their gasket will work well with anything below 60, if I recall...
Thanks for the responses! I did find a set of 4 rebuilt injectors on eBay for around 80. Fingers crossed on that!
Any ideas on where to get fuel injectors for the 2ZR-FXE motor without killing my budget? I've been quoted 145.00 each! I was thinking maybe get...
I've looked a bit more carefully at cylinder number 1. This was coincidentally the cleanest piston but I was thinking this was caused by a head...
Can someone tell me what the average roughness Ra of the cylinder head deck should be in order to seal properly with the 3 layer metal head...
