Separate names with a comma.
Over 6 hours later using the hobby charger to discharge, and it's still at 7.2 volts.
Cell #1 I discharged to 5 volts. Let it rest 30 minutes then started charging at 2.5A. I'm not sure if the charger didn't detect the delta peak or...
I am not sure just how accurate the capacity reading is on these hobby chargers. Starting back with the first cell after it was discharged the...
I tried to use the hobby charger to discharge, but the issue is while this hobby charger, as well as my previous one has 5A discharging rate, when...
Well since no one answered my questions, on the 2nd phase of discharging I am using the hobby charger to discharge. My question is..is one...
I was cleaning out the "belly" of the Prius today and found standing water in the spare tire area and the left rear bottom area, which would be...
I did some more reading on the discharge rates..and some people seem to use the same load (headlight bulb) for the same amount of time to record...
Welp, just charged two more modules, and no expansion that I can see.
Not sure...just the things I saw on YouTube. I bolted all the modules in except one, which was the last I charged and was still slightly "puffy"....
So how exactly are you guys keeping your packs from swelling? Even with 3 clamps on one module, 3.5amps, the battery was barely warm when I pulled...
I have to go to bed early, but this is my new "rig", dual output charger. Made compression blocks out of 2x6s, I still have to get another clamp...
I wonder if I could wire two modules together and charge 4 using a dual port charger (no one near me had quads)? Or is that not as good on the...
So once it hits 7500 it shuts off?
Im going to get a different charger to speed things up. Should I charge each module to a certain voltage or apply a certain amount of current for...
.45 amps? At 3 cycles, won't that take around 18 hours PER module? Your looking at what..500 hours? I also think some swelling is going to occur,...
Well I may have ruined the first battery by charging it with 6a of current, I also use the white plastic battery end caps to hold the module...
So general consensus online says to not discharge a NIMH below 1v/cell, or 6v in the case of a Prius module. But Prolong chargers says you can...
