Separate names with a comma.
I would get a low mileage JDM engine. My engine hydro-locked last fall on my 2010 Prius and I bought a JDM engine off of Ebay. Check with a...
What brand oil catch can did you use? I have an Evil energy catch can. Seems to be well made. Why would a manufacturer put in a dipstick if by...
Do you have a hose on the bottom valve? Is it easy to acess?. I felt this beats removing the can to pour it out as to wrecking the threads on the...
The added benefit of the Motorcycle fork tool is it has a steel wand rather than plastic which could deform with use from heat and chemicals. Plus...
[ATTACH]
After getting a JDM engine last fall I have been emptying my catch can at every oil change. It was getting old having to remove the catch can and...
Continental pure contact touring tires. I bought them at Discount Tire. Much better price than the Bridgestone Turanza quiettrack. Similar noise...
The combination of FatMat and sludge has definitely took some of the tire drone away. I would like to jack my car and remove the plastic panels...
Went with FatMat 4 layers thick and Spectrum sludge in the passenger side front wheel well. Figure I need to go big or go home. The combination...
It has the consistency of thin peanut butter and no need to add anything to it. Goes on dark blue and changes to black as it dries. Unfortunately...
I ended up with 3 layers of sludge over the top of the FatMat. The drying time is about 1 and 1/2 hours until it is dry to the touch. The picture...
Busy sound proofing my Gen 3 Prius five. I removed the driver side wheel well inner liner and I scrubbed it down with a mix of hot water and...
I just purchased a set of Continental control contact touring tires. I like them even better than the Bridgstone Turenza Quiettrack. Plus they are...
I have a 2010 Prius 5 with 17 inch wheels and dynamic radar cruise control and several years ago I put in a K&N air filter. I wash and reuse it...
The garage replaced it under warranty with another Duralast and 3 months later the ABS light was on. The internal speed sensor failed. They...
After test driving it I noticed that the front passenger bearing seems to have a bit of a drone while driving. I may just pay to have a garage do...
Are the fronts tougher than the rears? I heard you need to buy a special 32 point large socket to remove the compression nut.
Luckily it came out in one piece. I also sprayed seafoam deep creep on it too to help dissolve the rust and break it free.
Yes. Speed sensor was already disconnected. The sensor is attached with two tiny wires and it would have been torn out if not removed. I was also...
I put in a new Timken rear wheel bearing and hub assembly in my 2010 Prius tonight[ATTACH] [ATTACH] . I used some bolts and washers to pop the...
