Separate names with a comma.
I do not have any PIDs for RX400h, most likely it has to be built from scratch. Firstly, the user need to identify which protocol it is using. By...
The fan is optimized to run at the most efficient speed depending on the HV Battery temperatures. If you really want to manually control the fan...
Have you tried disconnecting the ScanGauge? There is a known issue with the SGII and our Gen1. If your SGII cable is the generic type, you may try...
jdcollins5 is right, that is for the Gen2. Gen3 has an additional Speed Reduction Gear (see attachments). I 've derived the relationship of MG1,...
navguy12 has made an easy to follow scangauge x-gauge for dummies. Vincent
Thanks for confirming it also works in Torque.:) I doubt you can enable/disable the automatic control. As what you suspected, the fan speed is...
It looks like those are not working. If you have time, could you please help to try by changing the formula to (F * 256 + G) / 10 ? Vincent
The VIN in range does not necessary mean it is included in the Service Campaign or Recall. The Japan website has these range: ZVW40-3000102 -...
I think Techstream can only connect when your car is on. Have you tried connecting TS with the car off in the 1st place? Vincent
I think the Ign-On one is the estimated value at the end of the previous use before you power down. This value is stored in non-volatile memory...
Adrian Black's spreadsheet only use 015B, the same one you 're using. It is true for some other PIDs but not applicable for SoC in the Gen3. In...
You can look at those with 21xx, others like 22xx, 24xx, etc are for other manufacturers' specific PIDs, e.g. GM, Ford, Mazda, etc. It will only...
According to the 2010 EWD, DLC3 pin16 is connected to an OBD 7.5A fuse then to the 140A Main fuse to the Aux. Battery. So pin16 is always hot as...
It is the official Toyota scantool diagnostic TechStream.:) Vincent
It was discussed in post #91. According to the Repair Manual, this PID should be a 16 bit number with no scaling. I don't understand why 8 bit...
The spec. has only 3 packs, where did you find the 4th pack? According to the presentation, Sub1 is used 1st followed by Sub2 and when Sub2 is...
HV battery is traction battery, there is only one Hybrid Vehicle battery AFAIK. I think you meant HV/EV mode switching. The SOC remains the same...
There are many ECUs that are unknown yet, what I do know are as below: ECU name|ID bits (11) Skid control|7B0 Combination meter|7C0 Air...
Thanks!:) I've corrected some of the errors, pls help to verify them. Vincent
Something like this but this is from 7E0, you need to change the ECU to 7E2. Thanks, Vincent
