Separate names with a comma.
A friend of mine once told me "you just can't make this shit up!". That's exactly what's going through my mind right now. Tom, didn't you...
If there's a defect with anything contained inside the battery case, and it's within the warranty time/miles requirement, the battery replacement...
My guess is that they can tell it is not original, because there should not be any black marker on any module. You are 100% incorrect with this...
I'm curious as to why you want to replace it. Are you seeing signs of failure or corrosion? My experience with Dorman remanufactured Gen 2 Prius...
and just to add to that, the end plate is what holds the white plastic tube that the rubber vent tubes attach. Then another rubber tube attaches...
What a bunch of rookies....... You should install the side plate that goes on the end of the HV battery, since the side plate is what has the...
Holy bejezzus. If the HV leak to the case was due to electrolyte seeping from a terminal and doiwn the side of the module, it will be cured...
Not guaranteed, but it's likely a P0AA6 HV isolation fault. Somewhere in the HV system (likely a module in the battery) has a high voltage leak to...
Yes. The Philips D4R 42406 was an OEM bulb for 2006-2009 gen 2 with HID option.
This is not correct. The ballast rarely is the failure point, compared to the bulbs themselves. The OP's symptoms of being able to relight the...
Absolutely. The new cases are about 7 or 8 bucks and are exactly that, an empty new case. Transfer all the internals including the RFID chip to...
If the magnets were broken loose, you need to clean all the old adhesive off the back of the magnet and the metal case. Use a very thin layer of...
I would be interested in it. I don't mind keeping some spare parts in the garage.
I have personally rebuilt 1000+ convertible top electric motor/pump assemblies. Some have very, very similar motors/brush assemblies as what you...
What car would you get with the following budgets (assuming you had to buy one right now)? $5,000--a decent Gen 2 $10,000--a decent Gen 2 and 555...
Ganador Muffler | PriusChat
Thought those were just the sides of the constant tension hose clamp
Good catch on all the corrosion at the bottom of the modules. Also, that nut with all the corrosion has pretty poor thread engagement compared to...
If the orange plastic is melted (appears like it to me) then you most likely have a poor connection. Heat is generated by current flowing through...
The CHST is in the engine cooling system, not the inverter cooling loop, so no worries for the inverter. You won't get any power out of the HV...
