Separate names with a comma.
Actually, the ultimate goal of China is to regain East Manchuria that was ceded to Russia in the 1850's. That includes Vladivostok and Sakhalin...
They should be adhesive lined and just pushed on. Match the curve to the curve in the door. That's about it. To assure good adhesion, I'd...
As I said in earlier postings, it's the unpredictable quality of the aluminum castings that make up the bore of the master cylinder and the pump...
I the old days, brake master cylinders has cast iron bores. They lasted many many years and were rebuilt many times. The bores were honed and...
Unfortunately, with the body of these units being aluminum castings, I am not sure that a rebuild will be as good as a brand new unit; the brand...
It might be a simple and inexpensive repair. The Toyota dealer is obligated to return the car to near original specification, and the are very...
I'd call it "worn out" or "end of serviceable life,"
The Gen 2 fuel filter is in the tank with the bladder. While the Gen 3 reverted to a standard design with a removable and removable filter pump...
Generation 4 used the same exhaust preheater which became very problematic in leaking resulting in the very expensive replacement of the who unit...
To be really safe, I do the 3 year coolant change interval.
As for the replacement water pump, I get a brand new Asin made OEM quality Toyota one. Any aluminum impeller one might not be better. A heavier...
No need to get every drop out. Just drain the radiator and get out as much as you can. The little that you can't get out by not opening the...
I would do 3-5 years or 50k miles or less coolant changes. 100k or 10 years initially is too long a period. I would be most concern about...
My dad's friend made this set up for a friend with a Tesla, but it can be done the same for a Toyota or any other scissors jack. It can be used...
Here is the complete removal and install manual for the Gen 3 exhaust including the catalytic converter.
Yes, not for atmospheric or environmental corrosion. It's to deter "two legged vermin corrosion" of the catalytic converter.
I prefer and use this one from Ryobi. There's no need to plug it in and drain the 12 volt. RYOBI ONE+ 18V Cordless High Pressure Inflator with...
The assembly is a somewhat complex construction. An aluminum angle fastened with countersunk sheet metal screws into a UHMW PE (Spectra) block....
That 2 ton low profile jack weighs close to 50 pounds and is hard to carry around and best moved on level pavement on it's wheels. I made this...
The two safest ways to lift a car for the avid do it yourselfer has to be the Bend Pack QuickJack and the Rennstand. Unfortunately, they have...
