Separate names with a comma.
Here is a photo of Mendel's chain wrap. [ATTACH]
Looks like the thief used an impact to unscrew the manifold attachment bolts. They owners could have thwarted the thief, if they used my Really...
Not asleep under a rock, dude! The thread was started in two years, ago in May 2021. It would be helpful if you gave us an idea of where on...
All parts should be interchangeable. There is no change between the two models... The 2018 is a continuous carryover of the 2017 model. 2017 was...
There should be no problem, since the spring fully supports the full weight of the rear corner of the car even with a moving load. It is much...
We developed this jacking plate to fit the center hole in the rear control arm. It allows one rear wheel to be raised no much than about two...
Years ago, I cut the panel off and installed an aluminum piano hinge with pop rivets and back up washers. 20 oil changes later, it's still there...
After reading about the experiences of many members on stolen Gen 3 cats, I decided to create this thread so that members can post their...
There is a vendor who sells these on Ebay. Close to $50 with shipping and taxes. [ATTACH] I prefer cheap.
The jacking socket is a hole punched into the rail of the aluminum chassis frame and formed by a dimple die. It is shown in this photo. [ATTACH]...
We maks special Tesla jacking adapters. Yesterday, we tried a few of our adapters on a new Model 3. The Model 3 always came with 25mm chassis...
Hope you used a 10.9 grade bolt and nut.
Not a Gen 2 but basically like the same offending rattle on my Prius v. When I first installed rge plate in 2017, fortunately, I used the rivet...
I used these to install the clamps. [ATTACH] Triplett TT-200 LongLockers 15-inch Extended Reach Locking Pliers with Non-Slip Handles, Red,...
Not all catalytic converter thieves are men. [MEDIA]
Yes, it's hard to remove unless you have a pair of extended length locking or needle nose pliers to pinch the ears to open the clamp to pull it...
No. I found that it was not necessary. The clamp stays securely in place by itself.
I started this thread on another layer of theft deterrent thats cheap, easy and inexpensive. The thief might do some damage, but you might be...
This method using the 5/8 inch spring hose clamp is so easy that I went out this afternoon and installed them on my 2012 Prius v. It will work on...
On a Gen 2, if the other end is cut off, it is easily repaired with one of these and some muffler sealant. It's cheap enough to get one in...
