Separate names with a comma.
I have a chance to look at the log file by Techstream, thanks to Paja! The Inverter Water Pump is showing 3500 rpm. So, if you change the MTH to...
It all depends at which point of the 12V bus you are measuring. If you use your DVM to measure the point close to the ECU, vlt may be more...
When you power off the car, SGII will wait for about 12 secs. when it detects no more CAN signals. Once it is timeout, SGII will save what were...
Adrian Black only uses MG1 temp. max. I'll check that again. It seems low, RM states 1375 to 5500 RPM in READY. Might need to adjust the...
It does sound like but I don't think it is clear. It does not tell you whether it is the SOC difference of the whole Bty Pack, the individual Bty...
Thanks Dwight:) Yes, I've a lot more, here are some of them: XGauge|TXD|RXF|RXD|MTH|NAM|Notes MG1...
Thanks Paja.:) Am I right to say the new formula for ICF, D * 9 / 17 + 15, is correct? Vincent
Thanks Dwight.:) The screen capture from The Critic also shows 0.0. I think it should be correct. [IMG] My Gen 1 is showing 20% all the time....
As long as it is < 60 °C, it is normal. ORNL did a test on the Gen2 and reported 50°C was not exceeded in a mild urban drive cycle, while 60°C...
No, it is not a typo, I actually corrected the error in this post. The Repair Manual refers Motor 2 as Transaxle and Motor 1 as MG2. Was the...
The multiplier 0.01 does not make sense, you will only get max. 2.55 %. I suggest try either G / 2 or G * 100 / 255. Vincent
Hi priusito_de_mi_vida & PaJa and others, Yes, I have updated the file and separated into US & Metrics into different worksheet. However, I need...
Thanks Dwight! As pointed out by motoleon, I've the offset wrong for these 2. It is easier to spot the error if I've the real data, sorry!...
You could be right about being gen 1 only. The Skid Control ECU in Gen 2 may have requested HV ECU to reduce torque on MG2 since the brake pedal...
If your ICE did not start, HV Bty was not at its max. load. The intention is to increase the accelerator to a point where HV Bty is at its max....
Re: What has been tried to solve the issue Scangauge also has some issues when it started to support multi-frame msg. I have not read this...
Your shift position is in [P] and the ICE was on, there was not much loading on the HV Battery, hence the small voltage difference. To do the...
OK, it seems like you have interpreted the offset incorrectly. Let's relook at your real data: Bit offset|0|8|10|18|20|28|30|38|40|48 Byte...
If you look at Adrian Black's spreadsheet change log, I created the BT1 ~ BT3 on 11/7 and BtT was already found so I did not change the NAM. On...
There is a setting in TS called "Room Light when Aprchd" - Lights up the power switch illumination, front interior lights, rear interior light and...
