Separate names with a comma.
You have to use the head option, your 1st row will be your header. It need not be in Bold, just my personal preference. e.g. [TABLE="head"]12V |...
Hi Flying White Dutchman, You can use y - 50 in Celsius. For Batt. temp., you can check out this link. Vincent
Hi 2009Prius, All your columns must be separate by "|" and every row should have the same no. of "|". Is this how you want your table to look...
Hi btrotter, You can look up the codes here but I don't think that has anything to do with your problem. My guess is that your HV Battery may...
Hi Mike, I think you were using the procedures from Maciej_S, there is 1 step missing. Hovik tried the instructions from the Repair Manual and it...
RXD would tell you the offset from the first bit of the response. However, there are some complications because some of the response are Single...
Re: Trying to find injector time Hi FreydNot, To convert to Torque, you need to do the reverse, i.e. divide by 10 to undo the formatting by the...
02EAX4610578 - First Frame msg. 010702EA0321 - Consecutive Frame msg. Pls refer back to this post for the explanation of FF and CF. CF do not...
Both your formulas agree with the Repair Manual: Min.: -64 kW, Max.: 63.5 kW I did not use Adrian's formulas because they are different from RM:...
Thanks frenchie for spotting the error!:) Have you found the correct HV battery discharge control and HV battery charge control? Vincent
Hi astrand, Yes, the "8" will add a dot if the results are between -99.9 and 99.9 inclusive. Otherwise, it will drop the dot, e.g. 100, only 3...
Oops! I'm sorry, it was my mistake.:( I sent it to the wrong ECU. XGauge|TXD|RXF|RXD|MTH|NAM|Notes MG1 Inverter...
Hi shizen, I think the procedures miss out one step. From the Repair Manual: Please try it and let us know if it works. Vincent
Hi Dwight, I have some PIDs which I think are those missing in the PID map. XGauge|TXD|RXF|RXD|MTH|NAM|Notes MG1 Inverter...
This ver. 6.20.020 is the latest, you might need to wait for their next release. Vincent
Hi timba-n-tango, It is a known bug in Techstream Lite (ver. 6.20.020) with Mongoose. Vincent
Thanks 2009Prius, I 've seen that article. However, there are many phrases he used that did not seem definitive to me: 1) I have devised a method...
Your SC300 is using non-CAN protocol ('97) so most probably it will also make use of pin14 on the OBDII connector for Ts signal. If that is the...
If I have a Gen2, I would have helped you to test but mine is a Gen1.:( Yes, changing the MTH will make your values multiply by 10 which should be...
Hi phdchp, CCL & CDL are described in this link. Unless your SOC goes below 40% or above 80%, these 2 values should be more than 0. It seems like...
