Separate names with a comma.
Hi ehybrid, I believe this xgauge was found by hobbit: http://www.techno-fandom.org/~hobbit/cars/can-split.html I think the reason for the...
Hi khp, You should be able to find it in your local store: Toyota Part: WIRE, FRAME, NO.2 Part NO.: 82165-47040 ToyoDIY.com Here is a pdf...
I've converted the SGII Xgauges to be used for Torque....
Hi wrenchy, Which high end snap on scanner? Bob Wilson has confirmed his AutoEnginuity does not retrieve Inf Codes on his '03. If the scanner can...
Hi Anthony, I can't access the video at my workplace. Anyway, here is a link to the RM for your P0420 code:...
Hi Anthony, Not all XGauge codes for CANSF are applicable for Gen2. You may try this XGauge: Gauge - Bank 1 - Sensor 1 TXD - 07E00124 RXF -...
It is just the opposite on the 2001-2003. There are module markings at the base case showing 1,5,10,15,20,25,30 & 35. Vincent
Thanks for trying!:) Yes, there are other low voltage malfunctions that have INF Codes but since you don't get any response, I suspect the result...
You got a point there, I was wondering it myself.:confused: Perhaps you can try mode $01 instead of mode $21? There are 5 INF Codes and each has...
Thanks!:) Yeah, the INF Code can only be read if you have certain DTC recorded. My warranty has already expired long ago so I have no problem...
That is a good question! My Gen 1 don't have this PID so I don't know the answer. I suppose if there were HV leakage, P3009 would be set? A good...
The original formula of -500 has a range of -500 to 520 Nm which do not agree with the Repair Manual. Your corrected formula has a range of -512...
Hi usbseawolf2000, Master Cylinder Control Torque doesn't seem right. It is either a single byte PID or the formula is wrong. The value can not...
Hi usbseawolf2000, The formula for the Temp. of MG1, MG2, MG1 Inv., MG2 Inv. and Conv. are meant for Gen3. Gen 1 & Gen 2 are using 50°C offset....
I doubt it because most, if not all, raw data are in metrics. Vincent
According to your spreadsheet, the formula for MG2 has a range of -500 to 7691.875 which is within the min. & max. torque of -500 and 500 Nm...
If you shift to [N], do you get 0 Nm for both torque? Once you get the offset correct, you can then figure out the scaling. Vincent
OK, I found the min. & max. temp....
If MG1 is trying to start ICE, system is already in [READY] mode and that means 12V battery must have enough power to supply to the ECUs and SMRs...
If you 're consistently getting 5 ~ 6 ºF higher than OAT, we need to relook at the offset. The offset is determined by the min. Temp. During...
