Separate names with a comma.
I may still be in denial since I bought the car new and it is still young, though the 12V battery may have been sitting in the dealer's lot...
Someone needs to be terminated for blowing my cover. :cool:
In addition to posting questions here I would also e-mail the manufacturer and see what kind of response I get. If the pre-sale support is not...
That's what I was thinking also. Someone (Hobbit?) said IGN 14 is good for efficient pulsing. I find it relatively easy to hit IGN 14 except when...
Quick update: A new photo taken through two mirrors - too lazy to set up the ramps and crawl under the car - the droplet is back again: [IMG]
When I had the car fully blocked last winter the highest coolant temp was 206F. The highest OAT was in the 50s. The trip was ~ 7 miles local and ~...
I bought my 2009 Prius new and have been rotating tires every 5000 miles (~ 6 months). The nuts are easily taken off every time with this 1/2"...
From what you described the dealer does seem incompetent and/or deceptive. I would look for other dealers or local shops for future...
Fellow PCer planetaire kindly provided the PID for the "run distance since last DTC clear" and I have been collecting data for a couple of days...
I usually get parts from my local Toyota dealer or one of the Toyota dealers that sell parts on line. Good luck! :)
Either one of the ECUs is "confused" or the HV battery is near the end of its life. Try disconnecting the 12V for a few minutes to reset the ECUs....
Check the seam in the middle of the plastic cowl cover to see if the seal has been broken allowing water to drip down and find its way into one of...
Is it possible to access that plug without removing the splash guard?
I believe clean plastic bottle is OK. It's Bob or Robert, not Bill. Standard test plus viscosity index if not already included. Good luck! :)
I don't think the size is that critical. As long as the pipe insulation fits snugly in the grill slots and doesn't fall out after a test drive you...
Without instrumentation to measure inverter temperatures I would block the upper grill fully and the lower grill partially (leaving 0.5 ~ 1 slit...
I would say near the middle. Definitely not the initial gush or the final drops. I would also clean the area around the outlet before taking off...
And mention "Bob Wilson" to get a special discount at R&G. Good luck! :)
I think for the electronics the cooler the better. I too would be worried and take some blocks off if I saw sustained 50C or above. On the other...
Thank you for sharing your experience! :) Yes even before starting the project I had considered the potential issue of sensory overload if there...
