Separate names with a comma.
Intermittents are tough. Could be localized overheating of a board, exercising cracked solder joints. Could also be a bad connector, but I would...
Removing the radiator cap o-ring unseals the system, placing less hydraulic pressure on any head gasket leak -- including after shutdown, during...
Meanwhile, ditch that dealer.
And the TRD bar is pretty meaty.
You nailed it with your observation that: "The water pump must continue to run to provide cabin heat because, the coolant temperature quickly...
The interior lights should progressively dim-out at shut-down, using the 12V as power, but it appears that the dimming has become a "burst-ing",...
I’ve never experienced RF interference with an LED lamp. Did these lamps have a separate driver box? If so, that’s what I would suspect was the RF...
Worse, some put out a sawtooth wave that will absolutely kill most electronics.
It depends entirely on the quality of the LED device and its alignment within the OEM housing. They range from spot-on to atrocious.
Seems as if the power pass through to USB port from the Entune box failed, along with the ‘System’. Software or hardware, I wonder?
My experience is that the muddy sound is a signal issue, from the head unit.
Thinking limit of adhesion, in this case...
Better, but still big.
Drifting through the snow is oddly calming, until the limit is reached and exceeded.
'Super Sticky' costs mpg, but 10 mpg on the basis of around 40 is a big hit.
May have used load resistors to mimic incandescents.
Hotchkiss sends bars without end links?
A loud noise... from/located where? Continuing until ICE has finished warming cycle, or time-dependent, or distance-dependent?
On the 2012 v Five LED turn signal lamps flash somewhat faster, but not epileptically so.
I fully expected that but didn’t see it. Perhaps LRR are smoother/cleaner out of the molds.
