Separate names with a comma.
I'm a bit at a loss about the bolts. I've seen plenty of these pieces after failure, and it's never been a fastener failure. Not sure why an...
They are 8mm, but for all intents and purposes, a 5/16 is identical (enough) to an 8mm Please remember, the torque is measured using INCH-pounds,...
I must say....I've never seen one do that before. I've seen the old style coils do similar stuff when they go bad and swell, but it never even...
The high voltage system of the car is totally isolated/insulated from the 12v system (and the car body). The P0AA6 code of which you speak is...
It's called the grounding bolt. It goes in the fastener hole toward the front on driver side, fastening the battery case to the floor.
Everything in the OP leads to the AC compressor circuit, where it apparently has a grounding fault. Every time defrost is used, the AC system runs...
I've always gone with the assumption that any car loaded onto anything by a fork truck is not going to look exactly the same afterward..............
If you have a jump pack connected to it, it apparently starts normally. What does it do if the jump pack is still connected to it when you try to...
The information below from Post #2 is 100% truth. I typically connect my trickle charger to freshen the 12v batteries in any of the Prii that...
I read this as he inadvertently touched one end of his tool to the (+) terminal while the other end was still in contact with the (-) terminal....
If I ever get one of my engines to it's end of life, where it's consuming more than a quart every 1k miles, I'm just going to go right to the top...
Anyone rebuilding a Gen 2 HV battery should use a new wire frame #2, which is the one that has all the voltage sensing tabs in front of the...
So the good news is the portion of the small print referring to cooling water is for radiator replacements only. They may have a grammatical error...
Yes, sometimes I used failed modules for fun experiments when I get bored..... I think it would take more torque to cause damage if the busbar...
The voltage measured at the battery terminals will always be slightly higher than what the car displays. The 12v battery in your car should be a...
The 7.0 to 7.4 spread is not the problem. The 7.0 is a problem. NO NiMH module in a battery pack should ever be that low. A healthy, 6 cell module...
I've experimented with this. With only a nut on the terminal stud (no busbar linking to the next stud), it took about 110 inch pounds to damage...
I had checked my 12v battery in my backup car last night. It's a 2006, with a 12v battery thats less than 12 months old. (made in 6/2019) it was...
Some info for you....this is in the engine control section of the repair manual. Around page 92. Any P0110, P0112 or P0113 (IAT sensor problems)...
Best way to tell would be voltage checks on the battery and checking for loose connections...even better if you have a battery tester or can take...
