Separate names with a comma.
I did the red T10 lights for the rear tail lights and have no problems. The front white T10's burned out rather quickly and I replaced them with...
Figure on $1,000 plus for the upgrade. The question is how many years do you plan to keep the car?
Sure they want your car and to SELL you a new one. They make 3 to 4 times the money when selling a late model used car as they do in selling a...
I bought a cheep Amazon ELM327 it didn't work with my tablet. I thought it was the Tablet's fault until I replaced my phone with Android version....
Around my area he would have pulled out his AK-47 to prove his point.
But aluminum would have saved you 6 maybe 7 ounces!
Yes, it's worth the money. It corrects Toyota's insistence on creating car's with massive amounts of understeer. My 2010 now goes where it's...
The 2010 is priced way too high. Did you check KBB for the prices in your area?
Yes an auto junk yard is probably your best source for the Gen II rear bar. I also see a few posted on ebay. Just be sure to get the mounting...
What most people use is a 24mm bar that was used on the 2002-2006 Matrix
A resistor is needed for turn signal lights. Otherwise they blink too fast.
I made the same mods as you. The front brace was the last part added and I was surprised at the improvement. The 2010's front and mid brace were...
Saving weight on lug nuts sounds like a potential safety issue to me. I want nice heavy steel nuts holding my wheels on.
You can buy a camera on Ebay that will snap into the factory hole in the hatch. The trick is to run the wires up thru the hatch - behind the side...
Gen four? Perhaps in 1 to 1 1/2 years. 2016 model released some time in 2015 is the best guess.
Headlight? - do not change them to HID - you will just blind the oncoming cars. Perhaps you need to polish the plastic? Mid brace? $59 is a...
No you can't drive the car with the mechanical key.
It's a Walmart - might be the highest crime area in Oakland from the stats I see. Don't use the fancy iphone where anyone can see you.
It's best done with a floor jack and two jack stands. Plus standard auto tools.
I don't see why in this case. On level ground there is no load on the bar or links.
