Separate names with a comma.
If you must be a Good Samaritan, there was nothing wrong with connecting the jumper cables directly to the 12V battery; that is much better than...
I am wondering why the procedure says not to use an impact wrench. I would expect to use an impact wrench to loosen the nut after it is unstaked.
Further, the last four digits can be hexadecimal, hence valid digits are 0 - 9 and A - F. The first digit is a letter, typically P for...
1. The engine coolant pump probably has failed. 2. Check engine coolant level in the reservoir behind the radiator; and ALSO in the radiator...
My idea is for you to check the inverter coolant pump to see if it is operational. When the Prius is READY, do you see fluid turbulence in the...
Your car has at least two problems: brake actuator and the left front wheel speed sensor. There may be additional faults related to the...
Bring a portable digital multimeter with you on your next test drive. When you notice the headlights changing intensity, immediately stop the...
Time to replace the 12V battery.
No, the 10 is a reference to 10 Newton-meter torque spec. See the note at the lower left corner of the page.
One photo seems to be a mirror image of the other, so one or the other probably got reversed while a digital image.
At worst, I would change the oil drain plug itself which should cost around $4.
Yes, you can say never mind, just change the engine oil/filter.
1. Have you figured out how the pan got dented originally; and if so can you avoid repeating whatever you did to dent the pan? 2. If you are...
Maybe, maybe not. Get the three-digit info codes associated with P0A78 and P0A94. Depending on the info codes, you might get additional clues...
I suggest that you should identify the part number and make sure the replacement has the same number. The RF frequency used by the fobs may vary...
I’m glad you found that diagram. I am not sure where T5 is; it may be above the blower/condenser assembly.
Ignore B1421, that just means the solar sensor is in the dark. A very good idea to use a hair dryer as a heat source to narrow down the problem.
Yes, wait until you are done working on all four corners. The front wheel alignment partially depends upon the thrust angle associated with the...
It just takes a minute to remove the cover and check the torque on the center nut, so you should do that.
Check tightness of battery cables including the negative cable at the body. If you don’t find a problem, buy a new 12V battery.
