Separate names with a comma.
I can only think of two possibilities. 1 is a problem with an axle shaft (inner joint not fully seated in the trans?). 2 is an internal...
What is the accumulator pressure sensor showing? When the warnings came on, did you press on the brake pedal the same amount as before? Did the...
What scantool do you have? Can it scan all 15-16 systems for codes? What does ECM (engine) data look like? Specifically, what are short and long...
What scantool do you have? Listen for the brake system pump. How often does it run? For how long? If the car sits in "ready mode" and you don't...
Those codes are for the ACCumulator and Front Right pressure sensor circuits. Use your Techstream - what do you see for sensor voltages? The...
If you clear codes, do they come right back? All those codes together indicate that the ABS ecu has a problem with the high current power feeds...
Hello and welcome to PriusChat! I have no idea if your warning lights are directly the result of "impact damage" or merely coincidental. Without...
A few years back there was a thread in the Gen2 forums that had links to a couple of VM's. These Virtual Machines had Techstream and drivers...
Torque can work, as can CarScanner. Really almost any generic OBD2 (engine data) app that is compatible with your phone and connection device...
True enough, but given all of the OP's recent posts, I would start with a complete inspection of the brakes. .
It has been awhile since I tried it but the Autel AP200 did work on iPhone. It's a pretty good general diagnostic scantool. Posted via the...
Have the braking system inspected by someone experienced with this type of work. .
Does the fuel pump work? What's the fuel pressure? Do the injectors "fire"? What does the scantool show for MAF readings while it spins? Do the...
So, the Hybrid vehicle Control ecu (the boss of the entire hybrid drive system) sets P3000 when the High Voltage battery ecu has codes (in this...
Something with the brake system - specifically for the left rear brake. Could be a number of things. Brake fluid leak, air in the system, brake...
Here's a US spec Gen2 Prius. Unplugging the connector shown at top left will disable the inverter pump and stop blowing AM2. It's easier to reach...
Oops, forgot the scantool link (again). So B1650 is the SRS - airbag ecu saying that there's some problem with the Occupant Classification...
Thanks for the link. .
Hello & welcome to PriusChat! Can't say if the corrosion you found is the smoking gun without knowing (seeing) exactly what-where it is. I think...
So if you have code P0A08, that's the hybrid control ecu having "issue" with the DC-DC converter (powers all the 12V stuff in the car). Could be...
