Separate names with a comma.
If you get a replacement case, be sure to transfer the RFID chip. It's a small "plastic" rectangle that's needed to have the fob work in the dash...
I first saw this type of oil seep years ago on Corollas - to the point where I call it "the Corolla triangle". The point where the block, cylinder...
I know that stuff, the inner CV joint has grease seeping past the large end of the boot and throwing it around. .
The lock cylinder in the driver's door has a mechanical link to the door latch - no power required. What I have seen on this type of system is...
Well, from what I have read here on the forums, most parts stores do not have scantools that are capable of checking all (or even most) of the...
Well, IF the Hybrid Control ecu is replaced, you need to perform a "handshake" procedure with the other ecu's on the car. This requires an OE...
You need a better scantool. Most are not capable of communicating with many of the systems on a Toyota hybrid. (This includes the scanners used by...
No idea. Without a scantool that can check all systems for codes, you have no idea either. All you know is that the Hybrid Control ecu detected at...
Yes, you would either need an annual subscription for a second car brand, or I would think that a second device (for a second brand) should work....
I don't know who "Lex Techs" are, but it doesn't sound like they gave you much information. Those are not very good (accurate?) code descriptions....
Hope it works for you, but be prepared if it doesn't. The part in front of the radiator is the condenser. I've done a few of them on various Gen...
The HV battery can't cause the P0016 code from the ECM. Best case is that the VVT (variable valve timing) solenoid on the engine is sticking -...
You can try your adapter with CarScanner and see what the ECT (engine coolant temperature) does. You want to listen carefully for the CHS pump to...
Autel has the AP2500 and the AP2500E. I do not see any difference between the two. So, the adcopy indicates that the "upgrade" is that it can...
I would use a capable scantool and see what the system does during a cold startup. Normally the ECM adjusts the 3-way coolant valve and runs the...
You certainly might need a replacement brake actuator assembly. I would do some testing first, as I have read about people replacing the...
No idea. The system may take 20-30 minutes of driving before it will realize that a sensor hasn't checked in and that it should turn the light...
I would think you might want to look up the diagnostic procedure for that code in the factory service manual. Possibly look at what the (2)...
It's not unusual for a high mileage car to run a bit "off" if it's been sitting for weeks. If your car uses a fair bit of oil, then you should...
What electrical connections did you disturb when you replaced your "trim panels"? Usually, I go to whatever it was that I touched and see if I...
