Separate names with a comma.
I read up on Infocar- the adcopy says it's an OBD2 scanner, so it mostly ECM (engine computer) data and functions. I don't see anything about...
Did you remove the transmission when you replaced the engine? First thing to do is inspect the connections and wiring for the trans. Don't drive...
What are you using to scan the car? Many budget devices can only talk to the ECM (engine computer) - maybe a few other systems. You need a fully...
Ok, I'm confused. Does the car run now or not? If the car was out of gas then the ICE can't run. That can reduce the pump's lifespan, but it...
Step one. Make sure the orange HV fuse holder interlock is fully seated. It's 3 steps. 1) insert the holder, 2) swing the lever in, 3) slide the...
If I understand the OP correctly, he took the "known good" pack out of his Gen3 (that has been in use) and put it into his Gen2 (that had been...
I have that Autel MS309 "scanner"- it's a decent (budget) device but ONLY does basic generic OBD functions from the ECM. As mentioned, it can't...
If you didn't move the wheel speed sensor during the initial axle replacement, then I doubt the sensor is the problem. More likely that the tone...
Air filters are cheap. If it bothers you then just replace it. But it would have to be really dirty before it affected mpg's. Lots of things can...
Four random tag on posts to old threads since joining yesterday? I'm not sure you should BOT-her responding. .
Side question- what app and OBD2 device are you using to scan the car? We have a thread covering scantool apps and want to keep it accurate and...
It's certainly possible that the ECM is faulty. Haven't seen it myself but there's a couple threads in the forums. Just be sure there's no damage...
1) You need a better scantool- if there are many warning lights coming on, then there are codes. Here's a thread that reviews several apps and...
Assuming that there isn't a fault with something like the fuel pump doesn't work, then a common cause of a "no start" on a Prius is carbon-goop...
Does the driver's door switch work properly? (that's one cause for master warning light) If the MFD you installed is the exact same number as the...
What scantool are you using? There might be a glitch with its bidirectional function. Most typical faults with the cooling fan will set codes in...
Your battery - charging behavior is normal for a Gen2 when the State Of Charge is low (gauge at 2 bars). The hybrid control ecu will not "waste"...
Personally, I like typing out my posts. It gives me time to think about what it is I AM saying vs what I WANT to say. Plus, I had to endure years...
Check the tone rings as suggested. See if any teeth are bent or the ring is cracked. Also check if there's any corrosion under the sensor...
Anything that you spray into the throttle body and intake manifold gets sucked into the cylinders and burned. Not sure how combusting the...
