Separate names with a comma.
I'm putting a Gen 2 back together after buying it at auction. I found a junkyard motor for it. This motor had a number plate on it that matched...
This pic is of the front left corner of the valve cover. I cut the quarter inch notch here to lift the fuel rail out of the way in preparation to...
So today I bought an auctioned 2007 Prius with 210K miles for 1,000 bucks. Body and interior are very good but there are rat droppings under the...
The following is from my experience removing the ICE from a 2013 Prius. I didn't have a lift and didn't need to remove the rest of the power train...
I recently completed an engine exchange in a 2013 Prius. The original cylinder head had the designation X2ZR-W25N and the donor motor had the same...
I just installed a junk yard motor into a Gen 3 Prius. While working on it, I removed the Hybrid Battery Safety Plug and disconnected the 12v...
I am trying to get the battery charged but it is below 6v after sitting with headlight switch in ON position for months. Other doors are open....
If the drive shafts are removed first, is it possible to remove the entire power train from the top? I've seen a YouTube video removing the engine...
I removed a complete engine/transaxle assembly from a junkyard Prius. I believe it is a good power train. The Prius I am using it for has a broken...
I removed a complete engine/transaxle assembly from a junkyard Prius. It appears the car was broken into and the hybrid battery was stolen....
I have a Gen 3 Prius I'm trying to get running again. It needs a new engine block at minimum, and I'm thinking of a junkyard engine to replace the...
I'm having trouble finding a Gen 3 motor without spending 1000 on eBay. Local pick n pulls really have no gen 3 cars. Any other cars used the same...
I replaced the head gasket on a gen 3 about 2K miles ago. Yesterday, the block developed a serious crack...Maybe an inch wide near the water pump....
I recently replaced the head gasket on a 3rd gen Prius. Water has leaked below the dash inside the car. I'm guessing this means I should have put...
I was told by the guy at the autoparts store today that electrocution is a real risk whe working on a hybrid. I disconnected the small 12v battery...
The Prius started right up with no clattering or noise from the timing chain. It does have a trouble light which I'm guessing was stored in the...
I have finally finished the head gasket but have two items left unconnected. One is electrical wiring about 3 feet long with a plastic plug on...
Just when I thougbt the difficulties were done!!!! I was torqueing the camshaft bolts. I used 12 ft lbs for the 10mm black ones and 20 ft lbs for...
I'm hoping I've figured this out correctly but just wanted to run it past someone. When I was taking the cylinder head off, I had removed the...
I need to know what to use to seal the camshaft housing, espeially right above the exhaust manifold. I have some Permatex Ultra Black the is good...
