Separate names with a comma.
Sell it on Craigslist?
Molybdenum disulfide is good stuff, but it makes a mess. I'd use it on anything that's metal on metal sliding friction. I can't think of many...
The 12V system is powered by the traction battery anytime the car is in Ready mode. And the engine can charge the traction battery in any gear...
Mine does work, it's just not loud enough to alert clueless distracted pedestrians. The best way to hear it would be in a garage with the...
It's not a problem to let the engine warm up on the highway. The warm up cycle still protects the engine and uses mostly EV power until it's...
I turned mine up from the default to the highest level using Carista, and I didn't notice any difference.
The load capacity at the recommended pressure (35/36 psi) is adequate. No need to increase it if you're loading the car within the payload limit...
It's easy to cheat if you don't start and end in the same place. My record is about 62 miles of all electric driving starting with the battery at...
What's your tire pressure, and what kind of tires do you have?
In the mountains, you'll likely hit the Charge Current Limit before the battery fills up. Normally the car allows around 40kW into the battery...
There are large parts of Colorado with no cell phone service or extremely unreliable service. Verizon and ATT are probably the best two networks,...
I had the Autel sensors installed yesterday, and they seem to be working. For anyone else considering them, note that most tire shops probably...
Are most rubber parts under a car oil resistant, or not?
Even more off topic, does anyone know if it's bad to spray Fluid Film on rubber parts like suspension bushings, rubber boots, etc? Or how bad is...
I suspect the aerosol fluid film has more solvents than the bulk kind. It bubbles and flashes off as you spray it. So you might be getting even...
I think you might be able to program them in the tire, although I haven't tested it. I programmed them on the floor, holding the tool next to the...
Since they seem to be reprogrammable, I guess you could try it and then change them to unique IDs if it's a problem. The OEM sensors put out a...
I always wonder if following trucks is worth the extra rock chips on the paint and windshield.
Since I have a programming tool now, I used unique IDs for the new sensors. While I had no sensors, the car would always pick up the signal from...
I found a way to test the sensors. I don't have any kind of pressure vessel, but I put them in an empty garden sprayer and pumped it up. That got...
