Separate names with a comma.
Second generation modules usually have a slightly higher internal resistance than 3rd generation ones, to check the internal resistance you might...
Before and after last reconditioning, this time the balancing voltage ended at 245v
Discharging below 1 volt is possible, it's risky , but it's necessary for reconditioning, it should be done at very low current and only...
Ok, The clips and all other chrome plates are in place, I removed the wear guide and rotated the pads.
Here are the pictures of pads and rotors. I removed strips, cleaned and regreased pins with marine rubber friendly grease, but as I push them in...
I would never have found out on my own. I will try to post some pictures tomorrow, the pad on the piston side is 9mm thick, it' s almost unused,...
I wonder what is the function of the flat metal stip on the piston side rear pad. I would like to rotate the pads because they are unevenly...
I found a hybrid report before the update, dcl and ccl are the same as after the update. I was not allowed to upload an html file, so I have...
I have trown the letter, but found the appointment in my agenda on 21/05/2019, I assume it's the SOSH-R66-1A
It would be interesting to roll back the update. Has anyone done that?
I don't know the Dcl before the campaign, but I see that the battery output is allowed spikes up to 28.6 Kw / 130a for a fration on second, then...
My prius did the LGG76B campaign, and the maximum DCL in hybrid assistant is 21KW, but I still see current spikes of 130 A at full trottle. 130A...
Are you still driving without issues with 0w-16?
You may find the instructions here Gen 3 HV cooling fan motor: wiring diagram? | PriusChat
I'm glad to hear it worked out also for you alsolooking.
I did't notice that, but if you fully discharge, then disconnect the bulbs, the voltage bounces back in few minutes.The hiccup shouldn' t last long.
It was from the front left wheel
I had the same noise when coming to a stop, I inspected the caliper pins, one was completely seized, a clean up with a steel brush, some grease ,...
I had the same water leak inear the 12 v battery, it was coming from the right tail light and I stopped it by applying some silicon to the...
Auch, yes the diodes could have prevented this, that some kind of silicone is resin.
