Separate names with a comma.
Hi Folks, We still are cruising around in our 2010 Prius IV, but have been without sound for a few years. It seems there are a few people who've...
had some body work done on the 2010 Prius (IV) front end. When we got it back, eventually found that the front turn signals aren't working....
For the sake of documentation, here's a photo showing the tools and where I used them. Refer to post #26 above, the end of the pry bar goes...
Success! I worked from underneath the car. I found a place I could get a pry bar like the one in Mendel's photo up through the subframe. Curved...
That's too bad, Nutz! I have been reviewing YT videos on removing stuck CV axles from random vehicles. Most methods are destructive, which is...
The problem with every pry tool I have, including one like that, is there is just nowhere to put them. If this were the right side, it would be...
I believe you, I just haven't found the spot or the tool yet. But I think I've figured out what to look for now. Lemme see if I can insert...
Thanks to both of you! I thought removing the knuckle-to-strut bolts would necessitate an alignment after reassembly. Is that not so? Mendel,...
That might account for why I can't find any videos or how-to's on replacing them. I've been following my Haynes manual which has you disconnect...
Well, I'm 1.5 hours into this, everything is going well, but I came back in to check the advice from @m.wynn about how to pry the cv axle out. I...
It doesn't look like other models share that part. Others in this forum may know better, but I conclude this because the part specified by...
^ Yep. I had the same trouble for some time when we first got the car. It's easy to hit the lock button instead of the open button.
If you are somewhere near the Twin Cities, consider taking either or both cars to CarSpec ( CARspec - Eden Prairie's Toyota and Lexus Auto Repair...
I made the same sort of mistake a couple months ago at an unfamiliar station in Minnesota. The labelling wasn't that obvious, and I thought it...
I am fairly certain that the leak is from the axle seal, there's far more oily dirt accumulated around the left side than the right. It's...
I have a '10, and even though I use a torque wrench to install the filter, it is always difficult to break loose 10,000 miles later. I, too, use...
I have to say, this has been a most informative and interesting thread, in both mechanical and cultural dimensions. I tend to come to fora such...
One of these days, I'm going to have to figure out how to run that solar-powered ventilation feature ... is yours not working, Jarrett?
Thanks folks. I checked it out today. There's enough of a leak to be letting fluid wick down one of the seams in the transaxle housing, and...
Hi Folks, 2010 Prius, 105K. I've got a little seepage from the driver's side transaxle seal, at the inner end of the driveshaft. 1. How common...
