Separate names with a comma.
Hi All, So the car was fine for a day or so, then the misfires came back... No idea if water found it's way in again, I'll have to pull coil...
Have you got a picture of yours PrimalPrius? That'd be interesting to see! My dad owned the car from new. If it was an aftermarket part someone...
Cheers guys! The (UK) passenger side of the cowl came off without any issues which allowed me to look at what was behind the cowl... Basically a...
As mentioned, the drains behind the cowls are clear and water that lands either side of the cowl drains out behind the wheel arches without a...
Hi Biomed, I'll get another (better) picture of it but you can see in the picture there's literally no holes for the water to drain out of when...
Hi guys, So after cleaning the drains out some heavy rain has deposited water in the plug holes again. Lifting up the bonnet causes a few...
Bisco, cheers! I think I've cleared the two holes. Hopefully the seal doesn't need replacing too... I hit it with a hose for a bit and it was dry...
Hi all. I'm under the bonnet again and cylinder 1 is full of water again. I didn't clean it out long ago. Cylinder 2 also had some. I'm cleaning...
Hi Camper, I just checked the tissues I dried it out with. It's definitely water. I don't believe coolant runs through the valve cover so I can...
Hey guys A few months ago I had some rough running and p0301 on my engine. I replaced all four spark plugs and the car has been doing ok since....
Hi guys, I recently found a lot of rust around my 12v battery while replacing it. Today I was replacing the rear lights and figured I'd look...
Hey guys, Can anyone confirm minimum disk thickness for front and back discs on a UK car? 05 plate... From using the search, it looks like 20mm...
Cheers Mr Guy Mann. I didn't notice the snowflake icon but if it occurs again i'll look for it. Unfortunately I only realised I can record data...
No mate. I'll do that next. Thanks.
Hi all, My dad's Prius gen 2 threw a tantrum today. I plugged in tech steam and saw the following errors: p0a80 p3000 I did a bit of googling...
Thanks TMR-JWAP So from that, is it safe for me to assume if I was to have to do this again in the future i could discharge at a higher rate...
Hi guys, So eventually the prius is back and working. For now at least. A few notes in case anyone ever has problems and crosses this thread......
Thanks HybridGuy. I won't bother trying to clean them then. When you say you wouldn't use anything that is 6.0 or lower, do you mean 6000mah...
Thanks mate... should I voltage test them with a load or without? What I've done so far is a quick discharge (1.4a) down to 6.5v and measured...
Cool! So maybe I'll charge them all to 6000mah then use the load tester (a volt meter and light bulb) to bring them all down to the same final...
