Separate names with a comma.
I was able to look the removal procedure up in my copy of the 2010 manual. Unfortunately the rotor is under the chain under the chain cover on...
I need to see how from the manual to do a visual check of the reluctor wheel on the crankshaft that my sensor is not reading. I was told by a...
None of that is likely. My new battery is functioning well. I've not had any problems with my engine since I had the head gasket replacement...
Installed the Denso crankshaft sensor, but still have the non start problem. So now I have to use the repair manual link and my old analog meter...
Thanks RJ, I have checked my original fuel pump out of the car and it works. I did replace it with a new Delphi pump. I replaced my crankshaft...
Thanks! I will look up the service manual and try what you suggest. I wrote DENSO a question about my use of a non DENSO crankshaft sensor and...
Thanks mr_guy_man. I would likely have to borrow an oscilloscope iff that's even possible. I'm unlikely to try getting Toyota to do that. The...
No...I don't have access to a scope. I don't have a clue, but do know that the original crankshaft sensor had a metal flake on it when I removed...
I'm going to the local library to look up the Chilton repair manual diagnostics for the P0335 code! I like ChapmanF recommended tests for the...
Alot of the LED lighting has special requirements, but in my case I found a type that come from China that don't need special electronics changes....
Hey RJ, Good point because the slight return and quick loss of power again is due to that 12v battery. I had this happen also. In my case the...
Thanks...I did not realize thats a relay cassette. Guess I'll have to pull it to take a closer look.
Thanks! The diagram showed it in the middle of the back edge of the car. And, Toyota replaced both my pos and neg 12v battery connectors ($120)
Sorry Brian, but the P0A80 code was still relevant....if you ask Toyota....they blame everything about this non start not on their own repair...
Hey ChapmanF, As you may know from another thread, I have had Toyota check my car. They claimed that the biggest problem was the failed hybrid...
Today I got confirmation from ChapmanF and independently from a Toyota parts supplier that had an "ask a question" option. Turns out of course...
Thanks Chapman! I also was able to get a confirmation on the same from a Toyota parts supplier that had an "ask a question" option. I really...
Yes...I only have a grinding disk for my black&decker...it's a bit dangerous to do that without a vise...which I don't have either!
Sorry Dogman, but it won't change what I wrote. I wish it weren't so!
Yep...and the tool that rockauto sent me was like that, but the posts are too thick to fit in the slots of the gen 3 lock ring. It's easy to look...
