Recent Activity

Activity stream for all registered members at PriusChat.

  1. Mendel Leisk liked ChapmanF's post in the thread Prius Prime Brakes.

    And the pins aren't even the only parts of the brakes that can stick, or even especially prone to it compared to other parts, for the...

    Apr 30, 2025 at 12:43 AM
  2. Mendel Leisk replied to the thread Disc Brake Caliper Slide Pin Grease(Lube)? Gen2.

    That’d be for me, if the quest was availability, price and “I have it on hand”.

    Apr 30, 2025 at 12:40 AM
  3. Mendel Leisk liked ChapmanF's post in the thread Disc Brake Caliper Slide Pin Grease(Lube)? Gen2.

    Nothing wrong with any of that, as long as people who come to PriusChat to find out what the manufacturer recommendations are do in fact...

    Apr 30, 2025 at 12:37 AM
  4. Mendel Leisk liked ChapmanF's post in the thread 2010 Prius diag mode blink codes.

    A dragging brake would not be the kind of thing the ECU would report as a wheel speed sensor problem. Even if it were dragging enough to...

    Apr 30, 2025 at 12:36 AM
  5. Mendel Leisk replied to the thread Confused: what could cause new front lower shield to pull off?.

    I guessed a bit at your frame number: https://www.amayama.com/en/genuine-catalogs/epc/toyota-usa/prius/ZVW30L/13501/body/5201 probably...

    Apr 30, 2025 at 12:36 AM
  6. MAX2 liked dolj's post in the thread No heat.

    ... and when MAX2 says plug, he means blockage. This was my thought, too. Either that or the air blend door under the dash is not...

    Apr 30, 2025 at 12:32 AM
  7. MAX2 replied to the thread No heat.

    There may be an airlock in the heater radiator, or debris from hoses or leak-eliminators may have accumulated. Channels with impaired...

    Apr 30, 2025 at 12:32 AM
  8. Mendel Leisk liked PriusCamper's post in the thread Monitoring Engine Temps.

    Yep... OBD2 port is not a reliable control port/data port for continuous use. It's just a legally required diagnostic port to use when...

    Apr 30, 2025 at 12:30 AM
  9. MAX2 replied to the thread Federal EV fees.

    The approach is certainly not well thought out. The impact on the road surface of a 3,500 pound vehicle is the same for an electric...

    Apr 30, 2025 at 12:25 AM
  10. PrimeDan liked Washingtonian's post in the thread Is fuel stabilizer necessary?.

    I probably shouldn't mention this, but some of these replies remind me of the tiger-proof fence I have in my back yard. It has been...

    Apr 30, 2025 at 12:20 AM
  11. PrimeDan liked Trollbait's post in the thread Is fuel stabilizer necessary?.

    In a sealed car tank, no. You might have some more hydrocarbon emissions coming off the car with winter blend during the summer, but a...

    Apr 30, 2025 at 12:19 AM
  12. PrimeDan liked Salamander_King's post in the thread Is fuel stabilizer necessary?.

    Yeah, I hear you. If my lawn is small and well maintained I would switch to an electric mowers. I really don't have lawn. I just have...

    Apr 30, 2025 at 12:19 AM
  13. bwilson4web liked ETC(SS)'s post in the thread Replacing my Model 3 battery.

    Good luck with the swap! I 'suspect' a detailed report will follow.... :)

    Apr 30, 2025 at 12:18 AM
  14. PrimeDan liked sam spade 2's post in the thread Is fuel stabilizer necessary?.

    But did you ever notice the gas engine running sometimes when it really didn't NEED to ? My guess is that it uses up some gas...

    Apr 30, 2025 at 12:18 AM
  15. rjparker attached a file to the thread Monitoring Engine Temps.

    Attached is the config pdf for the current P10 Pro model.

    Apr 30, 2025 at 12:17 AM
Loading...